![]() in which case, you may need to rotate the cutting stick to a clean surface. ![]() 1 – 2 turns each time) – You may also find that the orange cutting stick has begun to develop a groove? – this will also effect the cutting. – You may need to repeat the operation (using small turns of the grub screws. – Loosen the fixing screws slightly – This will allow the three small grub screws located on top of the blade housing to be turned clockwise, which will force the blade downwards (very slightly) – Re-tighten the blade fixing screws and test the cut operation once more. Lower the blade slightly (as if starting to make a single cut) – this will reveal the screws that hold the blade to the blade housing. – Should the paper not cut or not cut completely through, you can adjust the depth of the blade by turning the three small grub screws on the blade housing. Once the blade has returned up to it’s ‘home’ position, you should be able to move the cut piece away cleanly. ![]() When the blade is fully sharpened and set correctly, the cut should be made without any noticeable (or minimal) movement of the single sheet. Place a single sheet (ideally 100gsm bond – SRA3 in size) setting the 450vs+ Electric Paper Guillotine to 297mm depth. 450vs+ Electric Paper Guillotine – Adjusting the cutting depth and paper squareness ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |